Precision and Power for Professional Gimbal Systems

The iPower GM8112-80T Encoder Combo Set is engineered for high-end 3-axis gimbal systems that demand exceptional accuracy and smooth performance.
Equipped with AS5048A encoder technology, this combo delivers precise position feedback and ultra-stable motion control — ideal for SLR cameras, professional drones, and advanced cinematography setups.

Why Encoder Technology Matters

Encoders are advanced sensors that measure motor position in real time, enabling unmatched precision and control.
Compared to standard brushless gimbals, the GM8112-80T with encoder system offers:

• Up to 5× longer operating time through improved power efficiency
• Instant torque response and faster reaction to movement
• Superior stability even at extreme angles
• Simplified setup – minimal calibration required

The system combines active motor-driven stabilization with passive inertial balance, continuously monitoring movement across the Pan, Tilt, and Roll axes.
Each encoder-equipped motor reacts instantly to keep your footage smooth, steady, and cinematic.

Key Features

Easy gimbal tuning with minimal calibration

Power-efficient — up to 5× longer runtime than standard gimbals

Dual IMU sensors for enhanced stability

Instant torque response with no dead angles

Equipped with high-precision AS5048A encoder chip

Specifications

Model: GM8112

Motor Out Diameter: Ф89.5±0.05mm

Configuration: 36N/42P

Motor Height: 33.4±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): Ф25-0.008/-0.012 mm

Hollow Shaft(ID): Ф22+0.05/+0.1 mm

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 446±1g

Wire plug: 2.5mm dupont connector

No-load current: 0.3±0.1 A

No-load volts: 22V

No-load Rpm: 380~420 RPM

Load current: 2A

Load volts: 20V

Load torque(g): 6000-9000

Motor internal resistance: 4.2Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤80W

Working current: 3-5S

Working temperature: -20~60℃;10~90%RH

Compatible Sliprings

iPower Gimbal Motor Slipring - OD 7.9mm

iPower High Current Gimbal Metal Slipring - OD12.5mm

3 x GM8112 Gimbal Motor with AS5048A Encoder & Magnet

1 x Alexmos 32BIT BGC Board Encoder version without alum case

1 x Connecting cables set