Precision and Efficiency for Professional Gimbal Systems

The iPower GM6208-150T Brushless Gimbal Motor Combo is engineered for medium-to-heavy camera stabilization systems that demand exceptional accuracy, smooth motion, and efficient performance.
Equipped with the AS5048A encoder, each brushless motor provides real-time position feedback for precise stabilization, improved control response, and significantly increased power efficiency — delivering up to 5× longer working time compared to non-encoder systems.

How Encoder Technology Works

Encoders are high-resolution magnetic sensors integrated into each brushless motor of the gimbal.
They continuously track the motor’s rotation and position, allowing the controller to correct movement instantly and keep your camera perfectly balanced and stable.

The 3-axis stabilization system combines:

• Passive stabilization, which uses inertia to maintain balance on the Pan, Tilt, and Roll axes.
• Active stabilization, which relies on advanced sensors (IMUs and encoders) to measure motion and counteract unwanted shifts through motor feedback control.
• This hybrid approach delivers ultra-smooth, jitter-free footage with faster response and improved torque accuracy.

Key Features

Easy gimbal tuning with minimal calibration required

Power-efficient — up to 5× longer runtime than non-encoder systems

Dual IMU sensors for enhanced stability and control

Instant torque response for smooth and accurate motion

Integrated AS5048A encoder chip for real-time position feedback

Robust and lightweight brushless motor construction

Specifications

Model: GM6208

Motor Out Diameter: Ф69.5±0.05mm

Configuration: 24N/28P

Motor Height: 32±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): Ф25-0.01/-0.015 mm

Hollow Shaft(ID): Ф22+0.05/+0 mm

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 265±0.5g

Wire plug: 2.5mm dupont connector

No-load current: 0.08±0.1 A

No-load volts: 20 V

No-load Rpm: 209~231 RPM

Load current: 1.2 A

Load volts: 20 V

Load torque(g): 2600-3600

Motor internal resistance: 32Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤25W

Working current: 3-5S

Working temperature: -20~60℃;10~90%RH

Compatible Sliprings

None Available at this time

3 x GM6208 150T Gimbal Motor with AS5048A Encoder & Magnet

1 x Alexmos 32BIT BGC Board Encoder version without alum case

1 x Connecting cables set