Introducing the All-New Borg Series – Power Meets Precision!

The Borg Mini F7 Flight Controller (With Receiver) is custom-built for racing FPV and delivers exceptional performance. This advanced controller comes with a built-in ELRS 2.4GHz receiver and integrated antenna. It delivers a stable signal connection and smoother flight control during use.

Beyond its internal receiver, the Borg Mini F7 Flight Controller (With Receiver) also supports external receivers. This lets you tailor your device setup to fit your unique racing requirements. Upgrade your FPV racing experience with the state-of-the-art Borg Series!

Built-in ELRS 2.4GHz Receiver, while also being compatible with external antennas for enhanced flexibility.

Supports 4S to 8S battery inputs, offering versatility for various racing setups.  

Integrated 12V BEC provides stable power for your VTX system and allows remote control to switch it on and off. 

FPC cables ensure secure connections with ESCs, while SH1.0 connectors enhance reliability across all other interfaces.

Flight Controller Specifications

Input voltage: 4-8S; Support LIHV battery

MCU: STM32F722RET6

Gyro: ICM42688

OSD Chip: AT7456E（LGA）

Flash: 16MB (Blackbox flash)

UARTS: 6

Motor outputs: 4

I2C serial: Support

VTX protocol: support DJI MSP/Smartaudio/IRCTramp/HDZero

LED controller: Yes

Beeper pad: Yes

Betaflight Firmware target: IFLIGHT_BLITZ_F722

Mount pattern: 20*20 φ4

Dimensions: 34*28.5mm±1

Weight: 6.8g±1

BEC: 5V 2.5A, 12V 2A (12V with VTX switch)

Wiring Diagrams are available here.

SMD Receiver Specifications

MCU: ESP8285

RF: SX1281

Receiver Type: 2.4GHz

Telemetry power: 17mW (12.3dBm)

LNA: No

Lua Script: iFlight 2.4GHz Nano

TCXO: Yes

Firmware: iFlight 2.4GHz Nano RX

UART 1 for VTX HD / Analog

UART 2 for On-board Receiver

UART 3 for GPS or other sensors that require a serial port

UART 4 for GPS or other sensors that require a serial port

UART 5 for GPS or other sensors that require a serial port

UART 6 for ESC Telemet

1 x Borg Mini F7 Flight Controller With SMD Receiver

1 x Cable set

5 x silicon grommets

resource PINIO 1 C0

set pinio_config = 1,1,1,1

set pinio_box = 40,41,255,255

set box_user_1_name = VTX_ON_OFF

aux 0 40 8 900 2100 0 0

save