High-Precision Gimbal Encoder System – Smooth, Efficient, and Reliable

Encoders are advanced sensors integrated into each brushless motor of a gimbal stabilizer.
They allow the system to track motor position with high accuracy, resulting in superior stability, smoother motion, and greater power efficiency.
With real-time feedback from the A5048A encoder chip, this setup ensures faster response, stronger torque, and up to 5× longer battery life compared to non-encoder systems.

Key Features

Easy Gimbal Tuning: Minimal calibration required for quick setup.

Power Efficient: Up to 5× longer operating time than systems without encoders.

Single IMU Sensor: Reliable stabilization with lightweight performance.

Fast Torque Response: Immediate adjustment for precise and fluid motion.

High-Precision Encoder Chip: Built with the A5048A for accurate motor position tracking.

Model: GM2804

Motor Out Diameter: Ф35±0.05mm

Configuration: 12N/14P

Motor Height: 25±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): Ф8-0.008/-0.012 mm

Hollow Shaft(ID): Ф6.5+0.05/0 mm

Wire Length: 60±3mm

Cable AWG: #24

Motor Weight: 51±0.2g

Wire plug: PH3P connector

No-load current: 0.09±0.05 A

No-load volts: 10 V

No-load Rpm: 1602~1771 RPM

Load current: 0.8 A

Load volts: 10 V

Load torque(g): 250-350

Motor internal resistance: 9Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test: 

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤25W

Working current: 2-3S

Working temperature: -20~60℃;10~90%RH

Compatible Sliprings

iPower Gimbal Motor Slipring - OD 6.5mm

3 x GM2804 Gimbal Motor with AS5048A Encoder & Magnet

1 x Alexmos 32BIT Extended BGC Board Encoder version with alum case

1 x Connecting cables set