Elevate your long-range FPV experience with the DOGCOM 5000mAh 6S1P Li-Ion Battery, engineered for pilots who prioritize extended airtime, smooth cruising, and reliable efficiency.

Built with Samsung INR21700-50S cells, this pack offers a strong balance of energy density and discharge capability. It is designed for 5" to 7.5" long-range FPV platforms where efficiency, low weight, and controlled current draw are more important than aggressive throttle performance.

This battery is suitable for frames such as the Nazgul5, Evoque F5/F6, DC5, Chimera7, CineLR 7, and similar endurance-focused builds, depending on total aircraft weight, motor/propeller choice, payload, current draw, and flying style.

Important: This is a Li-Ion endurance battery, not a high-discharge freestyle LiPo. It is not intended for aggressive freestyle, racing, repeated full-throttle punch-outs, or setups that draw high current for long periods. For those applications, use a high-discharge LiPo pack.

Key Benefits

Premium Samsung INR21700-50S Li-Ion cells

5000mAh capacity for efficient long-range flying

6S1P configuration for compact size and low weight

Excellent energy density compared with typical high-discharge LiPo packs

Good balance of capacity and discharge capability

XT60 main connector and JST-XHR balance plug

Approx. 445g pack weight

Ideal for cruising, cinematic flying, long-range FPV, and endurance-focused builds

Estimated flight time around 15–18 minutes in typical long-range setups

Actual flight time depends heavily on drone type, total weight, motors, propellers, wind, altitude, temperature, payload, flight speed, throttle behaviour, battery condition, and landing voltage.

Li-Ion Battery Behaviour

Li-Ion batteries behave differently from standard FPV LiPo batteries.

Compared with high-discharge LiPo packs, Li-Ion batteries usually offer better energy density and longer cruising efficiency, but lower high-current capability and more voltage sag under load.

This battery is best used with smooth throttle control and efficient long-range flying. It may feel softer than a LiPo during hard acceleration or high-throttle manoeuvres. This is normal for Li-Ion chemistry and does not automatically mean the battery is defective.

For best results, use efficient motors, suitable propellers, low-to-medium throttle cruising, and a drone setup designed for long-range endurance.

Betaflight and OSD Voltage Warning Note

Most Betaflight and FPV OSD low-voltage warnings are commonly configured around standard LiPo behaviour.

When using Li-Ion batteries, voltage warnings may need to be adjusted by an experienced user. Li-Ion packs have a different voltage curve than LiPo packs and can show more voltage sag under load, especially at high current, in cold weather, or near the end of the flight.

Always monitor voltage per cell, consumed mAh, voltage sag under load, and resting voltage after landing. Do not rely only on default LiPo warning settings when flying Li-Ion packs.

Technical Specifications

Cell type: Samsung INR21700-50S Li-Ion

Configuration: 6S1P

Capacity: 5000mAh / 5.0Ah

Nominal cell voltage: 3.6V based on Samsung cell specification

Nominal pack voltage: 21.6V based on Samsung cell specification

Common FPV voltage reference: 22.2V based on 3.7V/cell convention

Nominal energy: approx. 108Wh based on 3.6V/cell

Common FPV energy reference: approx. 111Wh based on 3.7V/cell

Maximum charge voltage: 4.20V per cell

Maximum full pack voltage: 25.2V

Discharge cut-off voltage: 2.5V per cell absolute cell specification limit

Recommended end-flight voltage: approx. 2.9–3.1V per cell resting voltage, depending on load, setup, and safety margin

Cell-rated continuous discharge reference: approx. 35A

Maximum discharge reference: up to 45A only with suitable temperature protection, cooling, wiring, and operating conditions

Recommended practical continuous current for long-range FPV: approx. 20–25A

Calculated continuous C-rate at 35A: approx. 7C

Calculated maximum C-rate at 45A: approx. 9C

Calculated practical long-range C-rate at 20–25A: approx. 4C–5C

Connector: XT60 main connector

Balance connector: JST-XHR

Dimensions: 42 × 63 × 77mm

Weight: approx. 445g

Recommended ambient operating range for best performance and longevity: 15°C to 35°C

Cell Temperature Guidance

Recommended charging ambient temperature: 0°C to 45°C

Typical discharging ambient temperature: –20°C to 60°C

Avoid charging when the battery is below 0°C.

Avoid charging or using the battery when it is very hot, swollen, damaged, or behaving abnormally.

Cold Li-Ion cells can show stronger voltage sag and reduced usable capacity. High temperatures can accelerate ageing and may create unsafe conditions.

Charging Guidelines

Always use a Li-Ion compatible balance charger.

Charge mode: Li-Ion / lithium-ion balance charge

Maximum charge voltage: 4.20V per cell / 25.2V total for 6S

Recommended charge rate for normal use and long battery life: 1C or lower, up to 5A for this 5000mAh pack

Samsung standard charge reference: 2.5A

Samsung rated charge reference: 6A

Do not exceed 6A unless the battery label or pack manufacturer explicitly allows it.

Do not charge above 4.20V per cell.

Do not charge unattended.

Do not charge near flammable materials.

Do not charge below 0°C.

Do not charge a damaged, swollen, overheated, crashed, over-discharged, shorted, wet, or suspicious battery.

Stop charging immediately if the battery becomes hot, swollen, smells unusual, shows imbalance, or behaves abnormally.

Discharge and Landing Guidelines

This battery is designed for efficient cruising, not extreme current draw.

Recommended end-flight voltage: approx. 2.9–3.1V per cell resting voltage

The 2.5V per cell value is the absolute cell discharge cut-off specification, not a normal FPV landing target.

Voltage under load during flight can be lower than resting voltage after landing.

Avoid repeatedly discharging the pack to very low voltage, as this can reduce cycle life and increase the risk of cell imbalance or damage.

If voltage sag is excessive, land safely and check whether the battery is suitable for the drone, payload, propeller choice, current draw, and flying style.

Storage Guidelines

Recommended storage voltage: 3.7–3.85V per cell

Do not store fully charged for long periods.

Do not store empty or deeply discharged.

Disconnect the battery from the drone, charger, or any device after use.

Store in a cool, dry place, ideally between 15°C and 25°C.

Avoid high heat, direct sunlight, freezing temperatures, moisture, and physical damage.

Store in a fire-resistant battery bag, LiPo-safe storage bag, or suitable fire-resistant container.

Check the battery periodically during long-term storage.

If swelling, leakage, abnormal smell, corrosion, physical damage, or abnormal cell imbalance is detected, stop using the battery immediately and dispose of it safely according to local regulations.

Package Includes

1× DOGCOM 5000mAh 6S1P Li-Ion Battery with XT60 connector

Safety Disclaimer

Lithium batteries must be handled with care. Improper charging, over-charging, over-discharging, short-circuiting, overheating, physical damage, puncturing, disassembling, or incorrect use can cause fire, explosion, injury, or property damage.

Only use a compatible lithium-ion balance charger and always follow the charger instructions, battery label, and product specifications.

The user is responsible for selecting a suitable battery for their aircraft and operating it within safe voltage, current, temperature, and handling limits.

Do not use this battery if it has been crashed, punctured, swollen, overheated, over-discharged, shorted, exposed to water, or physically damaged.

By purchasing and using this product, the user accepts responsibility for safe handling, charging, storage, transport, and operation.