The DOGCOM 8000mAh 6S 120C LiPo Battery is a high-capacity, high-discharge battery designed for cinelifters, larger FPV drones, cinematic platforms, and professional UAV applications that require strong and stable 6S power delivery.

With 8000mAh capacity, 22.2V nominal voltage, and a manufacturer-rated 120C continuous discharge rating, this battery is built for demanding setups where reliable current output, stable voltage behaviour, and consistent throttle response are important.

This pack is suitable for larger 6S FPV drones and professional builds where the frame, motors, ESC, connector, wiring, propeller choice, payload, and total take-off weight are compatible with a large 8000mAh LiPo battery.

Key Benefits

Large 8000mAh capacity for extended flight time on suitable aircraft

6S voltage for powerful FPV and UAV applications

High-discharge LiPo pack for strong throttle response

Manufacturer-rated 120C continuous discharge

Manufacturer-rated 240C burst discharge

Designed for cinelifters, larger FPV drones, cinematic platforms, and professional UAV setups

Low internal resistance for efficient current delivery

Stable power output for demanding flights

No memory effect when charged, stored, and handled correctly

XT90 or XT60 connector depending on selected version

JST-XHR balance connector

Technical Specifications

Brand: DOGCOM

Battery type: LiPo / lithium polymer

Capacity: 8000mAh / 8.0Ah

Configuration: 6S1P

Cell count: 6 cells

Nominal voltage: 22.2V

Nominal cell voltage: 3.7V per cell

Maximum charge voltage: 4.20V per cell

Maximum full pack voltage: 25.2V

Recommended storage voltage: 3.80–3.85V per cell

Recommended landing voltage: approx. 3.5–3.7V per cell resting voltage, depending on aircraft load, flying style, and safety margin

Continuous discharge rating: 120C manufacturer rating

Burst discharge rating: 240C manufacturer rating

Calculated theoretical continuous current at 120C: 960A

Calculated theoretical burst current at 240C: 1920A

Important current note: C-rate values are manufacturer ratings and theoretical calculations. Real usable current is limited by battery temperature, voltage sag, connector type, wire gauge, solder joints, ESC, motors, airflow, aircraft setup, and flight duration.

Connector type: XT90 or XT60 depending on selected version

Balance connector: JST-XHR

Dimensions: 171 × 60 × 56mm

Weight: approx. 1175g

Documents:

UN38.3 Test Report

MSDS / SDS

Power Output

The 8000mAh capacity and 6S voltage make this battery suitable for larger aircraft that need a high-capacity power source with strong current delivery.

For best results, use this battery only on aircraft that are designed for its size and weight. Check frame recommendations, ESC rating, motor current draw, connector rating, wire gauge, propeller choice, payload, and expected current consumption before use.

A battery of this size is generally not suitable for small or lightweight FPV drones where the additional weight would reduce performance, efficiency, or handling.

Betaflight and OSD Voltage Warning Note

For 6S LiPo batteries, voltage warnings should be configured with a suitable safety margin.

Many FPV pilots use warning values around 3.5V per cell under load and aim to land around 3.5–3.7V per cell resting voltage, depending on aircraft type, current draw, payload, flying style, and safety margin.

Voltage under load can be lower than resting voltage after landing. Always monitor voltage per cell, consumed mAh, voltage sag under load, battery temperature, and resting voltage after landing.

Do not rely only on consumed mAh or only on voltage. Use both values together and leave enough reserve for a safe landing.

Charging Guidelines

Always use a LiPo-compatible balance charger.

Charge mode: LiPo balance charge

Maximum charge voltage: 4.20V per cell / 25.2V total for 6S

Recommended charge rate for normal use and longer battery life: 1C or lower

1C charge current for this 8000mAh pack: 8A

Only charge above 1C if the battery label or manufacturer explicitly allows it and your charger, power supply, cables, and safety setup are suitable.

Do not charge above 4.20V per cell.

Do not charge unattended.

Do not charge near flammable materials.

Do not charge a damaged, swollen, crashed, over-discharged, shorted, wet, or suspicious battery.

Do not charge when the battery is very cold or very hot.

Stop charging immediately if the battery becomes hot, swollen, smells unusual, shows imbalance, or behaves abnormally.

Discharge and Landing Guidelines

This battery is designed for high-current 6S operation, but it must still be used within safe voltage, current, and temperature limits.

Recommended landing voltage: approx. 3.5–3.7V per cell resting voltage

Avoid repeatedly discharging below 3.5V per cell resting voltage.

Avoid deep discharge, as this can permanently damage LiPo cells and increase the risk of swelling, imbalance, reduced performance, or unsafe behaviour.

Voltage under load during flight can be lower than the resting voltage after landing.

If voltage sag is excessive, land safely and check whether the battery is suitable for the aircraft, payload, propeller choice, connector, ESC, wiring, and flying style.

If the battery becomes unusually hot after flight, reduce load, check the setup, or choose a more suitable battery.

Storage Guidelines

Recommended storage voltage: 3.80–3.85V per cell

Do not store fully charged for long periods.

Do not store empty or deeply discharged.

After flying, bring the battery back to storage voltage if it will not be used again soon.

Disconnect the battery from the aircraft, charger, or any device after use.

Store in a cool, dry place, ideally between 15°C and 25°C.

Avoid high heat, direct sunlight, freezing temperatures, moisture, and physical damage.

Store in a fire-resistant battery bag, LiPo-safe storage bag, or suitable fire-resistant container.

Check the battery periodically during long-term storage.

If swelling, leakage, abnormal smell, corrosion, physical damage, or abnormal cell imbalance is detected, stop using the battery immediately and dispose of it safely according to local regulations.

Package Includes

1× DOGCOM 8000mAh 6S 120C LiPo Battery with XT90 or XT60 connector, depending on selected version

Safety Disclaimer

Lithium polymer batteries must be handled with care. Improper charging, over-charging, over-discharging, short-circuiting, overheating, physical damage, puncturing, disassembling, or incorrect use can cause fire, explosion, injury, or property damage.

Only use a compatible LiPo balance charger and always follow the charger instructions, battery label, and product specifications.

The user is responsible for selecting a suitable battery for their aircraft and operating it within safe voltage, current, temperature, handling, charging, storage, and transport limits.

Do not use this battery if it has been crashed, punctured, swollen, overheated, over-discharged, shorted, exposed to water, or physically damaged.

By purchasing and using this product, the user accepts responsibility for safe handling, charging, storage, transport, and operation.